Q. Shaft furnaces are used for

View solution

Q. Hearth furnaces are not used for

View solution

Q. Turn down ratio of a burner

View solution

Q. Which of the following is not a continuous waste heat recovery equipment from the flue gases going out of furnace ?

View solution

Q. Which is a regenerative furnace ?

View solution

Q. Which of the following accentuates clinker-ing troubles on furnace grate burning coal?

View solution

Q. The electric furnace in which heat is produced by a combination of induced current and skin effect is called __________ furnace.

View solution

Q. Ingress of cold air in the furnaces through cracks, charging doors, openings etc.

View solution

Q. Use of pulverised coal in boilers provides

View solution

Q. Regenerators are normally provided in the

View solution

Q. Metallic recuperators are not used for waste heat recovery, if the hot flue gas temperature is above __________ °C, because corrosion prevails at higher temperatures.

View solution

Q. Furnace pressure is normally controlled by regulating the

View solution

Q. An example of indirectly heated furnace is the

View solution

Q. Specific heating capacity of a furnace is expressed as

View solution

Q. Forced recirculation of furnace gases is practised

View solution

Q. Design of waste heat boiler for recovery of waste heat from furnace gases depends upon the

View solution

Q. Air filtration in a furnace

View solution

Q. Which of the following is the most important deterrants to an extended use of pulverised coal in boiler firing ?

View solution

Q. Which of the following is a periodic furnace?

View solution

Q. Test specimen for determination of refractoriness under load (RUL) of a refractory is heated in a

View solution