Q. 10 moles of C₆H₁₂ reacted with 18 moles of O₂, how many moles of CO₂ will produce?

View solution

Q. 5 moles of Al₂O₃ are reacted with 10 moles H₂SO₄, how many moles of Al₂(SO₄)3 will produce?

View solution

Q. 10 grams of NaCl and 1.8 grams of H₂O are reacted, how much sodium hydroxide will produce?

View solution

Q. 1 mole of potassium permanganate and 1 mole of ferrous sulfide are reacted in presence of excess hydroChloric acid, how many moles of Ferric sulfate will produce?

View solution

Q. Which of the following is the Claussius-Clayperon equation ?

View solution

Q. A flowsheet is given in the following figure. If the single pass once through conversion of A to B is 20%, then the rate of recycle R (molds/hr) is

View solution

Q. The equilibrium data of component A in the two phases B and C are given below. The estimate of Y for X = 4 by fitting a quadratic expression of a form Y = mX² for the above data is

View solution

Q. The reaction A + B → C has been conducted in a reactor as shown below. The number of balances (material) that can be made around the reactor are

View solution

Q. Acidity or alkanity of a solution is expressed by its pH value, which is defined as (where, [H⁺] = hydrogen ion concentration in the solution).

View solution

Q. Which equation is not an equation of state ?

View solution

Q. The reaction A + B → C has been conducted in a reactor as shown below. The number of boundaries around which material balance can be written, are

View solution

Q. Which of the following is not a colligative property ?

View solution

Q. Atoms of the same element, but of different masses are called

View solution

Q. If pH value of an acidic solution is decreased from 5 to 2, then the increase in its hydrogen ion concentration is __________ times.

View solution

Q. Kopp's rule is concerned with the calculation of

View solution

Q. Density of carbon dioxide is __________ kg/Nm³.

View solution

Q. One Newton is equal to __________ dynes.

View solution

Q. A very dilute solution is prepared by dissolving 'x₁' mole of solute in 'x₂' mole of a solvent. The mole fraction of solute is approximately equal to

View solution

Q. An ideal gas can be liquified, because

View solution

Q. The rate of material __________ is zero in case of a steady state system.

View solution