Q. The relation Ϫ² t =0 is referred to as

View solution

Q. The unit of thermal diffusivity is

View solution

Q. To effect a bond between two metal plates, 2.5 cm and 15 cm thick, heat is uniformly applied through the thinner plate by a radiant heat source. The bonding must be held at 320 K for a short time. When the heat source is adjusted to have a steady value of 43.5 k W/m², a thermocouple installed on the side of the thinner plate next to source indicates a temperature of 345 K. Calculate the temperature gradient for heat conduction through thinner plate. In the diagram, the upper plate is 2.5 cm thick while the lower is 15 cm thick.

View solution

Q. The diffusion equations
Ɏ²t + q g = (1/α) (d t/d r)
Governs the temperature distribution under unsteady heat flow through a homogenous and isotropic material. The Fourier equation follows from this expression when

View solution

Q. The famous Fourier series is named after

View solution

Q. Fourier law of heat conduction is best represented by

View solution

Q. Here are some assumptions that are made for Fourier law. Identify the wrong one

View solution

Q. Consider the following statements:

The Fourier heat conduction equation

Q = -k A d t /d x

Presumes

i) Steady state conditions

ii) Constant value of thermal conductivity

iii) Uniform temperature at the wall surface

iv) One dimensional heat flow

Which of these statements are correct?

View solution

Q. Negative sign in Fourier heat conduction equation indicates

View solution

Q. Transmission of heat i.e. molecular is smallest in case of

View solution

Q. Which one is not the unit of thermal conductivity?

View solution

Q. “Thermal conductivity represents the amount of heat conducted across unit area when a temperature difference of one kelvin”. True or false

View solution

Q. Which of the following is the unit of thermal resistance?

View solution

Q. Thermal conductivity is defined as the heat flow per unit time

View solution

Q. Mark the matter with least value of thermal conductivity

View solution

Q. Which one of the following forms of water have the highest value of thermal conductivity?

View solution

Q. The average thermal conductivities of water and air conform to the ratio

View solution

Q. Identify the very good insulator

View solution

Q. Most metals are good conductor of heat because of

View solution

Q. Heat conduction in gases is due to

View solution