Q. Which type of fall is not adopted in India?

View solution

Q. Canal drops are provided to _______________

View solution

Q. For a canal that irrigates the area directly the fall should be provided at a location FSL outstrips the G.L before the bed of the canal comes into the filling.

View solution

Q. In case of branch canals and distributary channels, the falls are located with consideration to _________________

View solution

Q. By providing a natural drop in one drop _______________________

View solution

Q. A canal fall is provided when the available natural slope is flatter than the designed bed slope of the channel.

View solution

Q. Consider the following statements.

I. Possibility of combining some other structure with a fall eg. regulator, road bridge etc.
II. Cutting and filling are required below and above the fall should not be necessarily equal.
III. The command should not be reduced due to the lowering of F.S.L and the fall may be located below the outlets.

Which of the following statement is correct for site selection of a fall?

View solution

Q. ______________ fall is adopted for smaller discharges and larger drops.

View solution

Q. Consider the following statements.

I. Syphon falls are commonly used where high levelled small drains do out-fall into a low levelled bigger drain.
II. The D/s well is necessary in case of falls greater than 1.8 m and for discharges greater than 0.29 cumecs.
III. The design discharge is determined based on the fact that V-notch is used.

Which of the following statement is correct?

View solution

Q. Calculate the velocity over the notch (V₁) and the velocity through the pipe (V₃) if the full supply discharge is 2 cumecs. The area of flow over the trapezoidal notch is 0.58 m². Assume the value of diameter of the pipe used as 1 m.

View solution

Q. What is the height of the centre of pressure above the water level in the inlet well if the R.L of the centre of pressure is 150.83 m and the R.L of water level in inlet well is 148.30 m?

View solution

Q. Calculate the diameter of the inlet well if the X and Y coordinate of the jet (issuing from the centre of pressure) w.r.t the water surface in the inlet well is 1.05 m and 1.88 m respectively.

View solution

Q. Which of the following loss is not considered while calculating the total head loss between the inlet well and D/s FSL?

View solution

Q. The discharge formula used in the design of the syphon well drop is ____________

View solution

Q. Which of the following statement is wrong?

View solution

Q. In what intervals the top width of the notch lies?

View solution

Q. By what value the thickness of notch pier should not be less than the water depth?

View solution

Q. The length of the weir will not exceed the bed width of the canal upstream, in case of trapezoidal notch fall.

View solution

Q. In case of design of sarda type fall the length of crest is kept equal to ____________

View solution

Q. In case of designing a sarda type fall the shape of the crest has one boundary level.

View solution