Q. Calculate full supply discharge for a free pipe outlet for the following data:

Head on the upstream side above the centre line of pipe = 0.55 m
Coefficient of discharge = 0.62
The diameter of the pipe = 25 cm

View solution

Q. Which module is mostly adopted and is considered to be the best of all the modules?

View solution

Q. Calculate the minimum modular head loss involved in ASOM if the head measured from the upstream water level in the distributary is 1.5 m and the width of the throat as 0.16 m.

View solution

Q. The proportionality of APM was sacrificed to enable the outlet to carry higher silt charge by increasing the setting to 8/10.

View solution

Q. Calculate the discharge through an open flume outlet for the following data:

Coefficient of discharge = 1.71
Width of the throat = 0.15 m
Head over the crest measured from FSL of distributary = 1.8 m

View solution

Q. The only irrigation semi-module through which the discharge is not proportional to H1/2 where H is the head causing flow through the module is _____________

View solution

Q. An irrigation outlet is said to be proportional, when its ______________

View solution

Q. The principal feature of an ASOM is similar to those of a flume regulator.

View solution

Q. Choose the incorrect advantage of AOSM.

View solution

Q. For a wide trapezoidal channel, the channel index is ______

View solution

Q. Which of the following is not a type of rigid module?

View solution

Q. The discharge range of Gibb’s module varies from ____________

View solution

Q. Choose the incorrect statement.

i. Bed bars are constructed in canals at the toe of the canal lining to prevent slippage of the lining.
ii. Cattle crossings also provide safety to cattle that are swept away by currents besides their usual function of helping the cattle to cross the canal.
iii. A canal escape helps in supplying irrigation water to the downstream watercourses.

View solution

Q. The outlet discharge is maintained constant and it is not at all dependent on the water levels in the parent and the field channels in _________________

View solution

Q. Gibb’s module is a type of outlet which ensures constant discharge even if the water levels in the supply channel and watercourse fluctuate.

View solution

Q. A baffle wall is a sort of weir constructed at the end of the cistern to:

i. To prevent any excess amount of discharge likely to pass through the module
ii. The baffle plates are inserted in the eddy chamber sloping from the outer wall towards the inner wall
iii. Head up the water to its upstream to such a height that hydraulic jump is formed

Which of the following statement is correct?

View solution

Q. In cattle crossings, the exact distance to be kept between the two ramps on the same side should theoretically be ________

View solution

Q. For canals carrying smaller water depths, a ramp is provided for the entry and exit as cattle crossings.

View solution

Q. Bed bars are used _______________

i. To serve as permanent reference marks
ii. To correct alignment and theoretical bed levels of the canal
iii. Helps in desilting the canal section during its maintenance

Which of the following function of bed bars is/ are correct?

View solution

Q. Gibb’s module holds good for the standard design in which _________

View solution