Q. “The diameter of well does not have any effect on temperature measurement by the thermometer”. Choose the correct option

View solution

Q. Which fin yields the maximum heat flow per unit weight?

View solution

Q. Heat dissipation by every segment of the fin is

View solution

Q. “If a fin of a constant cross section is used, there would be wastage of material”. Chose the correct option.

View solution

Q. Which one is true regarding parabolic fin?

View solution

Q. For parabolic fin, the curve follows which law?

View solution

Q. The correction length for cylindrical fin is
(Where, d is the diameter)

View solution

Q. Provision of fins on a given heat transfer surface will be more effective if there is

View solution

Q. The heat dissipation at any section of parabolic fin is given by

View solution

Q. Which one is true regarding rectangular fin?

View solution

Q. Analysis of heat flow from the finned surface is made with the following assumptions
(i) Uniform heat transfer coefficient, h over the entire fin surface
(ii) No heat generation within the fin generation
(iii) Homogenous material
Identify the correct option

View solution

Q. If heat conducted into the element at plane x is Q X = – k A C (d t/d x) X. Then heat conducted out of the element at plane (x + d x) is

View solution

Q. A heating unit is made in the form of a vertical tube of 50 mm outside diameter and 1.2 m height. The tube is fitted with 20 steel fins of rectangular section with height 40 mm and thickness 2.5 mm. The temperature at the base of fin is 75 degree Celsius, the surrounding air temperature is 20 degree Celsius and the heat transfer coefficient between the fin as well as the tube surface and the surrounding air is 9.5 W/m² K. If thermal conductivity of the fin material is 55 W/m K, find the amount of heat transferred from the tube without fin

View solution

Q. For steady flow of heat along a rod, the general equation is
d²α/dx² – m² α = 0
The value of constant m is

View solution

Q. In convection from the tip, we introduced a factor known as

View solution

Q. Find the value of corrected length for rectangular fin?
Where, b is width and t is length of the fin

View solution

Q. Which one is true for the spine?

View solution

Q. In convection from the tip what is the value of correction length?

View solution

Q. Let us assume there are two pieces of copper wire 0.1625 cm in diameter with a device that melts it at 195 degree Celsius. The wires are positioned vertically in air at 24 degree Celsius and the heat transfer coefficient of the wire is 17 W/ square m K. Let us say k = 335W/m K i.e. of wire. Find out the energy input?

View solution

Q. The figure shows a 5 cm diameter rod, 90 cm long, which is having its lower face grinded smooth. The remainder of the rod is exposed to 32 degree Celsius room air and a surface coefficient heat transfer equal to 6.8 W/m² degree exists between the rod surface and the room air. The grinder dissipates mechanical energy at the rate of 35 W. If thermal conductivity of rod material is 41.5 W/m degree, find the temperature of the rod at the point where the grinding is taking place

View solution