Q. Which of the following criteria has to be satisfied for no tension at any point on a gravity dam?

View solution

Q. The bottom portion of a concrete or a masonry gravity dam is usually stepped in order to _______

View solution

Q. The governing compressive stress in a concrete gravity dam which should not be allowed to exceed the permissible value of about 3000 KN/m² while analyzing full reservoir case is ____________________

View solution

Q. If the uplift increases and the net effective downward force reduces, the resultant will shift towards the toe.

View solution

Q. When the reservoir is empty, the single force acting on it is the self-weight of the dam which acts at a distance of ____________

View solution

Q. When the reservoir is empty, the maximum vertical stress equal to ________________

View solution

Q. The two-dimensional stability analysis of gravity dams proves better for U-shaped valleys than for V-shaped valleys.

View solution

Q. Calculate the value of minimum base width for an elementary triangular concrete gravity dam supporting 72 m height of reservoir water and full uplift? (Take specific gravity of concrete as 2.4 and coefficient of friction as 0.7)

View solution

Q. For usual values of permissible compressive stress and specific gravity of concrete, a high concrete gravity is the one whose height exceeds ______________

View solution

Q. For triangular dam section of height H for just no tension under the action of water pressure, self-weight and uplift pressure, the minimum base width required is _____________

View solution

Q. If the eccentricity of the resultant falls outside the middle third, the ultimate failure of the dam occurs by ______________

View solution

Q. What is the value of eccentricity for no tension condition in the dam?

View solution

Q. Calculate the top width of the dam if the height of water stored is 84m.

View solution

Q. In high dams, the safety against sliding should be checked only for friction.

View solution

Q. For full reservoir condition in a gravity dam, the critical combination of vertical and horizontal earthquake accelerations to be considered for checking the stability is ________________________

View solution

Q. The base width of a solid gravity dam is 35 m and the specific gravity of dam material is 2.45. What is the approximate allowable height of the dam having an elementary profile without considering the uplift?

View solution

Q. A low gravity dam of elementary profile made up of concrete of relative density 2.57 and safe allowable stress of foundation material 4.2 MPa. What is the maximum height of the dam without considering the uplift force?

View solution

Q. The vertical stress at the toe was found to be 3.44 MPa at the base of the gravity dam section. If the downstream face of the dam has a slope of 0.617 horizontal: 1 vertical, the maximum principal stress at the toe of the dam when there is no tailwater is _______________

View solution

Q. What is the recommended value of shear friction factor against sliding?

View solution

Q. The small openings made in the huge body of a concrete gravity dam such as sluices and inspection galleries can be assumed to be causing only local effects without any appreciable effect on the distribution of stresses as per the principle of_____________________

View solution