Q. The thin cylinder theory for designing arch dams is based only on ___________________

View solution

Q. The temperature stresses producing worst effects in the design of arch dams are caused by ______________

View solution

Q. The stresses due to rib-shortening become quite important in the case of _____________

View solution

Q. Which of the following is not the basis for the design of an arch dam?

View solution

Q. According to thin cylinder theory, the volume of concrete required for an arch dam would be minimum if the central angle is ____________

View solution

Q. The best design of an arch dam is when __________________

View solution

Q. At a given elevation, the thickness of the arch ring is proportional to the radius of the arch.

View solution

Q. The load from the deck of a buttress dam is transmitted to the foundations through the ______

View solution

Q. Multiple arch dams are generally used for ______________

View solution

Q. Which of the following dam requires no reinforcement?

View solution

Q. Which of the following dam is also known as the Amberson dam?

View solution

Q. Which of the following component of a buttress dam is also called counterfort?

View solution

Q. Which of the following type of dam requires very strong and stable foundations and is not in use as much as the other types?

View solution

Q. Which of the following is the earliest recorded multiple arch buttress dam?

View solution

Q. In a simple deck slab buttress dam of a given height, the buttress spacing can be increased by increasing the upstream slope.

View solution

Q. The buttresses of a free deck buttress dam are provided at ‘x’ m clear spacing and buttress thickness is proposed to be ‘t’ m. The buttress section can then be designed like the section of a concrete gravity dam by considering the effective unit weight of water = Surcharge factor (S) x actual unit weight of water. The value of this surcharge factor is given as _____________

View solution

Q. What is the suggested economic buttress spacing for a mean dam height of greater than 45 m?

View solution

Q. What is the suggested slenderness ratio for simply supported RCC decks?

View solution

Q. What is suggested massiveness factor for simply supported RCC Decks?

View solution