Q. What is the factor of safety?

View solution

Q. What is Hooke’s law for the 1-D system?

View solution

Q. Limit of proportionality depends upon ____________

View solution

Q. The stress at which extension of a material takes place more quickly as compared to the increase in load is called ____________

View solution

Q. Which of these is a non-hoookean material?

View solution

Q. Where in the stress-strain curve, the hooke’s law is valid?

View solution

Q. Highest value of stress for which Hooke’s law is applicable for a given material is called ____________

View solution

Q. The slope of the stress-strain curve in the elastic deformation region is ____________

View solution

Q. What is the stress-strain curve?

View solution

Q. Which point on the stress strain curve occurs after the proportionality limit?

View solution

Q. Which point on the stress strain curve occurs after the lower yield point?

View solution

Q. Which point on the stress strain curve occurs after yield plateau?

View solution

Q. Which point on the stress strain curve occurs after the ultimate point?

View solution

Q. Elastic limit is the point ____________

View solution

Q. Where is the necking region?

View solution

Q. The property of a material by which it can be drawn into thin wires is?

View solution

Q. If the material has identical elastic properties in all directions, it is called ____________

View solution

Q. Why is the strain the fundamental property but not the stress?

View solution

Q. The material in which large deformation is possible before absolute failure by rupture is called ____________

View solution

Q. What is a creep?

View solution