Q. A tensile load of 100kN is gradually applied to a rectangular bar of dimension 2cmx4cm and length of 5m. What will be the strain energy in the bar if E=1×10⁵ N/mm²?

View solution

Q. A tensile load of 60kN is gradually applied to a circular bar of 4cm diameter and 10m long. What will be the strain energy absorbed by the rod if E=1×10⁵ N/mm²?

View solution

Q. A uniform bar has a cross sectional area of 700mm and a length of 1.5m. if the stress at the elastic limit is 160 N/mm, what will be the value of gradually applied load which will produce the same extension as that produced by the suddenly applied load above?

View solution

Q. A tension bar 6m long is made up of two parts, 4m of its length has cross sectional area of 12.5cm while the remaining 2m has 25cm. An axial load 5tonnes is gradually applied. What will be the total strain energy produced if E = 2 x 10⁶ kgf/cm²?

View solution

Q. What is the strain energy stored in a body when the load is applied with impact?

View solution

Q. What is the value of stress induced in the rod due to impact load?

View solution

Q. What will be the stress induced in the rod if the height through which load is dropped is zero?

View solution

Q. A weight of 10kN falls by 30mm on a collar rigidly attached to a vertical bar 4m long and 1000mm² in section. What will be the instantaneous stress (E=210GPa)?

View solution

Q. A load of 100N falls through a height of 2cm onto a collar rigidly attached to the lower end of a vertical bar 1.5m long and of 105cm² cross- sectional area. The upper end of the vertical bar is fixed. What is the maximum instantaneous stress induced in the vertical bar if E = 200GPa?

View solution

Q. A weight of 10kN falls by 30mm on a collar rigidly attached to a vertical bar 4m long and 1000mm² in section. What will be the strain (E=210GPa)?

View solution

Q. A load of 100N falls through a height of 2cm onto a collar rigidly attached to the lower end of a vertical bar 1.5m long and of 105cm² cross- sectional area. The upper end of the vertical bar is fixed. What is the maximum instantaneous elongation in the vertical bar if E = 200GPa?

View solution

Q. A load of 100N falls through a height of 2cm onto a collar rigidly attached to the lower end of a vertical bar 1.5m long and of 105cm² cross- sectional area. The upper end of the vertical bar is fixed. What is the strain energy stored in the vertical bar if E = 200GPa?

View solution

Q. The maximum instantaneous extension, produced by an unknown falling weight in a vertical bar of length 3m. What will be the instantaneous stress induced in the vertical bar and the value of unknown weight if E = 200GPa?

View solution

Q. The maximum instantaneous extension, produced by an unknown falling weight through a height of 4cm in a vertical bar of length 3m and of cross section area 5cm². What will be the instantaneous stress induced in the vertical bar and the value of unknown weight if E = 200GPa?

View solution

Q. An unknown weight falls through a height of 10mm on a collar rigidly attached to a lower end of a vertical bar 500cm long. If E =200GPa what will be the value of stress?

View solution