Q. In continuous beams ______________ moments is always less than support moments.

View solution

Q. Lighter materials of construction can be used for a continuous beam.

View solution

Q. ________ is a good example for malleability.

View solution

Q. Determine the working stress in the factor of safety is 3 and ultimate load is what 127.32N?

View solution

Q. Volumetric strain = 3× _____________

View solution

Q. The approximate percentage of steel taken for lintels in the absence of detailed design is _______

View solution

Q. Mix proportion for M20 grade mix is _________

View solution

Q. The limit state corresponding to deflection, cracking and vibrations are _______

View solution

Q. In reinforcing of Steel bars, the end and side covers are taken as ____________ to ____________ mm.

View solution

Q. The field capacity of a soil depends upon _____________ factor.

View solution

Q. According to Fannings formula the flood discharge in cumecs is given by Q = ______________

View solution

Q. The estimate of flood can be made by using ____________

View solution

Q. In simply supported slabs, alternate bars are curtailed at ________

View solution

Q. The length of the staircase between two consecutive landings is called _______

View solution

Q. ________ is used in the entrance of cinema theatres and shopping malls.

View solution

Q. In the design of lintel, determine the base angle of a triangle for poor masonry.

View solution

Q. Calculate the height of the equilateral triangle in the design of lintel, if the masonry used is poor graded. Take effective span as 1.29 m.

View solution

Q. For a simply supported beam, the basic l/d ratio should be ____________

View solution

Q. A beam of clear span 6 metres is supported on bearings of 150 mm if the effective depth of a beam is 400 mm. calculate the effective span.

View solution

Q. The final deflection of horizontal members will be the level of casting should not exceed _____________

View solution