Q. In sliding failure, the co-efficient of friction varies from ________

View solution

Q. Which of the following forces do not act on the dam?

View solution

Q. The elementary profile of a dam is generally a ________

View solution

Q. _____ acts as an inspection chamber in Dams.

View solution

Q. The minimum standard height for a construction joint is about ________

View solution

Q. Cracks developed in the body of dam section can be avoided by ________

View solution

Q. ______ is the over flow section or portion of the dam.

View solution

Q. _______ is the common type of spillway used in gravity dams.

View solution

Q. Which of the following is not a failure of a rectangular dam?

View solution

Q. Structural failures contribute about _______________ in the failure of dam.

View solution

Q. The free board is provided in dams to avoid _______________

View solution

Q. By providing ______________ gully formation can be avoided.

View solution

Q. The maintenance of the reservoirs, above _____________ Ha comes under irrigation department.

View solution

Q. Which of the following process will you prefer to prevent the leakage of water in the dam foundation?

View solution

Q. ______ grouting increases the bearing capacity of soil.

View solution

Q. According to IS, the specific gravity of a good building stone used in heavy dams should be ______

View solution

Q. Hardness can be measured using _______

View solution

Q. Granite has been widely used for dams construction because of _______

View solution

Q. The range of slenderness ratio in dams varies from ________

View solution

Q. _______ is provided for installation of control equipment of valves in dams.

View solution