Q. The major losses of energy due to friction are calculated by using _________

View solution

Q. The ratio of A/P is ___________

View solution

Q. Determine the velocity of flow in a pipe if the discharge capacity is 270 litres per second and cross sectional area is 5 cm².

View solution

Q. Calculate the reaction at prop of cantilever, if the span of beam is 5m and load is 20 kN.

View solution

Q. The highest point on syphon is known as ____

View solution

Q. The position between the summit and the lower reservoir is known as ___________

View solution

Q. Full form of TEL is _________

View solution

Q. The sheet of water flowing through a notch is called Nappe.

View solution

Q. The width of broad gauge is ___________

View solution

Q. Which of the following gauge is the Indian Standard Gauge?

View solution

Q. _____ is the weakest part in railway track.

View solution

Q. About 90% railway tracks laid with ___________ rails in the world.

View solution

Q. Brass is an example of ____________

View solution

Q. A beam which is inbuilt in at its support is called _________

View solution

Q. Fixed beam is also known as _______

View solution

Q. In fixed beams, the slope at the supports be ___________

View solution

Q. _______ changes induce large stresses in a fixed beam.

View solution

Q. A beam 6 metres long is fixed at it ends. It carries a udl of 5 kN/m. Find the maximum bending moment in the beam.

View solution

Q. Calculate the maximum deflection of a fixed beam carrying udl of 5 kN/m. The span of beam is 6 m. Take E = 200kN/m² and I = 5×10⁷ mm⁴.

View solution

Q. Calculate the load intensity of fixed beam if the maximum deflection shall not exceed 1/ 400 of the span. Take EI as 10¹⁰ kN mm².

View solution