Q. Theorotical velocity = _______

View solution

Q. Which of the following is not a hydraulic coefficient?

View solution

Q. Bell mouthed orifices can be categorised in according to ___________

View solution

Q. The section which has a minimum cross sectional are in a flow is known as _______

View solution

Q. A mouthpiece is a short length of a pipe which is not more than __________ times its diameter.

View solution

Q. _____ is a small opening made in the bottom or sides of a tank.

View solution

Q. A propped cantilever beam carrying total load “W” distributed evenly over its entire length calculate the vertical force required in the prop.

View solution

Q. In propped cantilevers, the prop reaction is 3/8 wl.

View solution

Q. A fixed beam of the uniform section is carrying a point load at the centre, if the moment of inertia of the middle half portion is reduced to half its previous value, then the fixed end moments will ______

View solution

Q. The maximum negative bending moment in fixed beam carrying udl occurs at ________

View solution

Q. Glass is an example of _________

View solution

Q. Find out the elongation of a tie of 2m long, if the axial rigidity is 5000 × 10⁴ mm². The axial pull be 20 kN.

View solution

Q. ____________ is used to empty a tank of water having no outlet.

View solution

Q. A Straight cantilever of uniform area carries a udl over its entire length. If the free end of a cantilever is now prop at the level of the fixed end, the vertical force required at the prop be __________

View solution

Q. Flow of water when a tap is just open is an example of __________ flow.

View solution

Q. Bernoulli’s equation is applicable only for ___________ flow.

View solution

Q. Which of the following is the coefficient of pitot tube?

View solution

Q. Which of the following devices measures the velocity of flow?

View solution

Q. Pascal’s law is applied in ____________

View solution

Q. Which of the following device is not based on Bernoulli’s equation?

View solution