Q. Which of the following is known as Re-entrant mouthpiece?

View solution

Q. Micrometre contraction gauge is used to determine ___________

View solution

Q. What is the general value for coefficient of contraction?

View solution

Q. The Cd value for internal mouthpiece running free is __________

View solution

Q. _______ is the velocity with which water reaches the notch or before it flows over it.

View solution

Q. Which of the following formula was proposed by Bazin?

View solution

Q. For measuring low discharges _____________ notch is preferred.

View solution

Q. Which of the following is also known as V notch?

View solution

Q. Calculate the discharge over rectangular Weir of 3 metres length under the head of 400mm.Use Francis formula.

View solution

Q. _____ converts mechanical energy into hydraulic energy.

View solution

Q. Torsional sectional modulus is also known as _________

View solution

Q. ________ is a measure of the strength of shaft in rotation.

View solution

Q. What are the units of torsional rigidity?

View solution

Q. The angle of twist can be written as ________

View solution

Q. The power transmitted by shaft SI system is given by __________

View solution

Q. Area of catchment is measured in ___________

View solution

Q. ______ catchment area is a sum of free catchment area and intercepted catchment area.

View solution

Q. ___________ has steep slopes and gives more run off.

View solution

Q. How many number of rain gauge stations should be installed an area between 250 to 500 km².

View solution

Q. Trend of rainfall can be studied from _______

View solution