Q. _________ reinforcement is designed for sections where the bending moment is maximum.

View solution

Q. In case of __________ beams, the 50% of bars are curtailed at a distance of 0.5 ×l.

View solution

Q. Splices are provided when the ________ bar available is less than that required.

View solution

Q. Lap splices should not be used for bars larger than __________ mm.

View solution

Q. Cantilever slab is categorised based on support conditions.

View solution

Q. According to IS 456: 2000; the span to depth ratio of a simply supported beam is ___________

View solution

Q. The __________ of the slab is governed by span to depth ratio.

View solution

Q. The material does not possessing any kind of elastic symmetry, then the material is said to be _______

View solution

Q. What is the ratio of maximum deflection to maximum bending stress if a simply supported rectangular beam of span “L” and it carries a central load W.

View solution

Q. In a cantilever of span subjected to a point load of w acting at a distance of (1/3) L from free end. The deflection under load will be

View solution

Q. The slabs whose corners are prevented from lifting are known as _________

View solution

Q. As the corners are held down ___________ reinforcement has to be provided at the corners.

View solution

Q. Which of the following layout is used for “Direct- Indirect system”.

View solution

Q. ________ layout is best suited for well planned towns.

View solution

Q. A ___ is used to prevent water from flowing back in the opposite direction.

View solution

Q. Scour valve in water distribution system is provided at ________

View solution

Q. _______ valves are known as “Washout ” valves.

View solution

Q. Check valve is provided on the delivery side of a pipe.

View solution

Q. _____ reduces the pipe size from larger to smaller bore.

View solution

Q. The maximum pressure in (kg/cm²) to which cast iron pipes may be subjected is _________

View solution