Q. For a duct of rectangular cross-section with length l and breadth b, the value of d e is

View solution

Q. In many flow situations, the duct can be

(i) Circular
(ii) Rectangle
(iii) Trapezoidal
(iv) Annulus

Identify the correct option

View solution

Q. If an annulus has an inner diameter of d₁ and an outer diameter of d₂ then the equivalent diameter is

View solution

Q. Conduction plus fluid flow in motion is known as

View solution

Q. How many types of convection are there?

View solution

Q. Which of the following heat flow situations pertains to free or natural convection?

View solution

Q. Mark the system where heat transfer is given by forced convection

View solution

Q. Forced convection in a liquid bath is caused by

View solution

Q. A finned tube hot water radiator with a fan blowing air over it is kept in rooms during winter. The major portion of the heat transfer from the radiation is due to

View solution

Q. A body cooling from 80 degree Celsius to 70 degree Celsius takes 10 minutes when left exposed to environmental conditions. If the body is to cool further from 70 degree Celsius to 60 degree Celsius under the same external conditions, it will take

View solution

Q. On a summer day, a scooter rider feels more comfortable while on the move than while at a stop light because

View solution

Q. What is the value of convective coefficient of oil in case of forced convection?

View solution

Q. A sphere, a cube and a thin circular plate, all made of the same material and having the same mass are initially heated to the temperature of 250 degree Celsius. When left in air at room temperature, what will be their response to cooling?

View solution

Q. Newton-Rikhman law is given by

View solution

Q. The value of film coefficient is dependent upon

(i) Boundary layer configuration
(ii) Geometry and orientation of the surface
(iii) Surface conditions

View solution

Q. The convection coefficients for boiling and condensation lie in the range

View solution

Q. Forced air flows over a convection heat exchanger in a room heater, resulting in a convective heat transfer coefficient 1.136 k W/m² K. The surface temperature of heat exchanger may be considered constant at 65 degree Celsius, and the air is at 20 degree Celsius. Determine the heat exchanger surface area required for 8.8 k W of heating

View solution

Q. A region of fluid motion near a plate in which temperature gradient exist is

View solution

Q. Thermo-physical properties of the fluid are represented by

(i) Density
(ii) Viscosity
(iii) Specific heat
(iv) Thermal conductivity

Identify the correct option

View solution

Q. A motor cycle cylinder consists of ten fins, each 150 mm outside diameter and 75 mm inside diameter. The average fin temperature is 500 degree Celsius and the surrounding air is at 20 degree Celsius temperature. Make calculations for the rate of heat dissipation from the cylinder fins by convection when motor cycle is stationary and convective coefficient is 6 W/m² K

View solution