Q. Which one is having lowest value of specific heat?

View solution

Q. What is the value of specific heat for coal in J/kg K?

View solution

Q. What is the value of specific heat for cotton in J/kg K?

View solution

Q. What is the value of specific heat for sand in J/kg K?

View solution

Q. Which one is having highest value of overall heat transfer coefficient?

View solution

Q. What is the value of overall heat transfer coefficient for air to heavy tars and liquid?

View solution

Q. What is the value of overall heat transfer coefficient for air to low viscosity liquid?

View solution

Q. Which one is having lowest value of overall heat transfer coefficient?

View solution

Q. What is the value of overall heat transfer coefficient for air condensers?

View solution

Q. What is the value of overall heat transfer coefficient ammonia condensers?

View solution

Q. What is the value of overall heat transfer coefficient for steam condensers?

View solution

Q. Capacity ratio is defined as the product of

View solution

Q. Which of the following is not associated with heat exchanger?

View solution

Q. The engine oil at 150 degree Celsius is cooled to 80 degree Celsius in a parallel flow heat exchanger by water entering at 25 degree Celsius and leaving at 60 degree Celsius. Estimate the exchanger effectiveness

View solution

Q. In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Celsius to 75 degree Celsius. The steam condenses on the outside surface of tubes at atmospheric pressure and the overall heat transfer coefficient is estimated at 860 k J/m² hr degree. Find the effectiveness of the heat exchanger. At the condensing pressure, stream has saturation temperature 0f 100 degree Celsius and the latent heat of vaporization is 2160 k J/kg. Further, the steam is initially just saturated and the condensate leaves the exchanger without sub-cooling i.e. only latent heat of condensing steam is transferred to water. Take specific heat of water as 4 k J/kg K

View solution

Q. For evaporators and condensers, for the given conditions, the logarithmic mean temperature difference for parallel flow is

View solution

Q. Water (specific heat = 4 k J/kg K) enters a cross flow exchanger (both fluids unmixed) at 15 degree Celsius and flows at the rate of 7.5 kg/s. It cools air (C P = 1 k J/kg K) flowing at the rate of 10 kg/s from an inlet temperature of 120 degree Celsius. For an overall heat transfer coefficient of 780 k J/m² hr degree and the surface area is 240 m², determine the NTU

View solution

Q. Pick the odd one out.

View solution

Q. A cross flow type air heater has an area of 50 cm². The overall heat transfer coefficient is 100 W/m² K and heat capacity of both hot and cold stream is 1000 W/m K. The value of NTU is

View solution

Q. After expansion from a gas turbine, the hot exhaust gases are used to heat the compressed air from a compressor with the help of a cross flow heat exchanger of 0.8 effectiveness. What is the number of transfer units of the heat exchanger?

View solution