Q. The bubble diameter at the time of detachment from the surface can be worked out from the relation proposed by

View solution

Q. For n-tubes in a vertical column of the tube bank pattern, identify the correct statement.
(Where, D is the diameter of a single tube in the bank)

View solution

Q. Kirk bride criterion is given by

View solution

Q. What is the value of Reynolds number in terms of mass flow rate?
(Where, δ is length of the plate and b is width of the plate)

View solution

Q. What is the value of characteristics length in turbulent film condensation?
(Where, δ is length of the plate)

View solution

Q. The outer surface of a vertical tube is 1.25 m long and outer diameter is 50 mm is exposed to saturated steam at atmospheric pressure. If the tube surface is maintained at 80 degree Celsius by the flow of cooling water through it, determine the rate of heat transfer to the coolant

View solution

Q. A condenser is to be designed to condense 225.0 kg of steam per hour at a pressure of 0.15 bar. A square array of 400 tubes, each of 6 mm in diameter, is available for the task. If the tube surface temperature is to be maintained at 26 degree Celsius, make calculations for the length of the tube

View solution

Q. The transition from laminar to turbulent flow occurs at a critical Reynolds number of

View solution

Q. Which parameter is responsible for commencement of the turbulent flow?

View solution

Q. Which of the following is a wrong statement in the context of a convective heat transfer coefficient in laminar film condensation?

The heat transfer coefficient varies as

View solution

Q. The critical Reynolds number for transition from laminar to turbulent film condensation is

View solution

Q. Determine the length of a 25 cm outer diameter tube if the condensate formed on the surface of the tube is to be same whether it is kept vertical or horizontal

View solution

Q. A plate condenser of dimensions l * b has been designed to be kept with side l in the vertical position. However due to oversight during erection and installation, it was fixed with side b vertical. How would this affect the heat transfer? Assume laminar conditions and same thermos-physical properties and take b = l/2

View solution

Q. Mark the wrong statement with respect to laminar flow condensation on a vertical plate

View solution

Q. For laminar film condensation on a vertical plate, the gravitational acceleration g is replaced by

View solution

Q. For laminar film condensation on a vertical plate, the mass flow rate of the condensate per unit depth of the film at any position x is given by

View solution

Q. For laminar film condensation on a vertical plate, the velocity distribution at a distance δ from the top edge is given by

View solution

Q. Milk spills over when it is boiled in an open vessel. The boiling of milk at this instant is referred to as

View solution

Q. All the following statements are correct, except

View solution

Q. Which of the following parameters affect burnout heat flux in the nucleate boiling region

(i) Heat of evaporation
(ii) Temperature difference
(iii) Density of vapor
(iv) Density of liquid
(v) Surface tension at the vapor-liquid interface

Mark the correct answer from the codes indicated below

View solution