Question
a.
1.75 kN/m²
b.
1.89 kN/m²
c.
17.9 kN/m²
d.
17.6 g/cm²
Posted under Geotechnical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The shear strength of the soil, at the liquid limit is ________
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The apparatus used for finding, WL value by static cone penetrometer method is _________
View solution
Q. Which of the following apparatus does not include, in a determination of shrinkage limit?
View solution
Q. The density of the mercury, used in shrinkage limit apparatus is _________
View solution
Q. The inside of the shrinkage dish is coated with a thin layer of _________
View solution
Q. The volume of the wet soil, present in shrinkage dish_________ of volume of dish.
View solution
Q. What are the ways of preventing of inclusion of air bubbles in shrinkage dish?
View solution
Q. The Density of water, used in shrinkage limit test is _________
View solution
Q. The volume shrinkage (VS) is defined by the formula _________
View solution
Q. The shrinkage ratio of soil is equal__________ the soil in its dry state.
View solution
Q. Shrinking limit can be found out using alternate method, if __________
View solution
Q. The filed density of a natural soil deposit cannot be determined by_____ method.
View solution
Q. Arrange the following to obtain the correct procedure of sand replacement method.
I. Measurement of soil density
II. Determination of water content and dry density
III. Calibration of the cylinder
View solution
Q. For calibration of cylinder _______ is used.
View solution
Q. Arrange the following to obtain the correct procedure of soil density by sand replacement method.
I. Cylinder is placed over a tray
II. Tray with central hoe is placed in ground
III. Test hole is dug
IV. The cylinder valve is opened
View solution
Q. In sand replacement method, if the mass of sand filling the calibrating container is 1450g and volume of calibrating container is 1000cm³, then its buk density is_______ g/cm³.
View solution
Q. The IS code for determination of dry density by sand replacement method is ________
View solution
Q. The inner diameter of the core cutter is_____ cm.
View solution
Q. The principle of submerged mass density method is_______
View solution
Q. The plasticity of clay depends on which of the following?
View solution
Q. The typical activity value of illite, present in clay is________
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Geotechnical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!