Q. The settlement ratio for a negative projecting conduit is __________

View solution

Q. The magnitude and direction of relative movements between the interior and exterior prisms of the conduits are dependent upon the ___________

View solution

Q. Critical plane in conduit is located at ___________

View solution

Q. If the critical plane settles more than the top of the conduit, the settlement ratio is __________

View solution

Q. Both the projection condition and the ditch conditions of a positive projecting conduit may be __________

View solution

Q. If the plane of settlement does not fall within the embankment, then such a condition is called _________

View solution

Q. The sign used for complete projection is __________

View solution

Q. The recommended value of settlement ratio for embankment, to use in design is __________

View solution

Q. The load on a negative conduit is given by the equation __________

View solution

Q. A soil engineers usually encounter problems of stress distribution in __________

View solution

Q. The problem of stress distribution in the vicinity of shafts was first solved by ________

View solution

Q. The method given by Biot for solving the problem of stress distribution was based on ________

View solution

Q. The stress component which acts on any point in the surrounding material before the excavation of the shaft can be resolved into __________ parts.

View solution

Q. Stress due to equivalent fluid pressure can be found out using __________

View solution

Q. After excavating the shaft, the shearing stresses along the walls of the shaft will be equal to ___________

View solution

Q. When the high value of σϴ in the vicinity of the walls of a shaft exceeds the compressive strength it results in __________

View solution

Q. The stress component at any point, after the excavation of the shaft, will be equal to ____________

View solution

Q. Underground conduits are commonly used for, which of the following purpose?

View solution

Q. A ditch conduits can be installed in a __________

View solution

Q. Underground conduits can be classified into ___________ types.

View solution