Q. Which of the following values of K0 is used to compute the stress in the vicinity of a cylindrical tunnel?

View solution

Q. Which of the following conduit is installed in shallow bedding?

View solution

Q. The transfer of pressure from a yielding part of soil mass to the less yielding part is defined by the term __________

View solution

Q. The problem of computing the stress in the vicinity of a cylindrical tunnel was solved by __________

View solution

Q. Ditch conduits are more commonly used in ___________

View solution

Q. Underground conduits can be classified into ___________ types.

View solution

Q. A ditch conduits can be installed in a __________

View solution

Q. Underground conduits are commonly used for, which of the following purpose?

View solution

Q. The stress component at any point, after the excavation of the shaft, will be equal to ____________

View solution

Q. When the high value of σϴ in the vicinity of the walls of a shaft exceeds the compressive strength it results in __________

View solution

Q. After excavating the shaft, the shearing stresses along the walls of the shaft will be equal to ___________

View solution

Q. Stress due to equivalent fluid pressure can be found out using __________

View solution

Q. The stress component which acts on any point in the surrounding material before the excavation of the shaft can be resolved into __________ parts.

View solution

Q. The method given by Biot for solving the problem of stress distribution was based on ________

View solution

Q. The problem of stress distribution in the vicinity of shafts was first solved by ________

View solution

Q. A soil engineers usually encounter problems of stress distribution in __________

View solution

Q. The load on a negative conduit is given by the equation __________

View solution

Q. The recommended value of settlement ratio for embankment, to use in design is __________

View solution

Q. The sign used for complete projection is __________

View solution

Q. If the plane of settlement does not fall within the embankment, then such a condition is called _________

View solution