Q. In the limiting case of stability, the angle of slope is referred to as _____________

View solution

Q. The factor of safety against safety is given by ________ equation.

View solution

Q. A basic type of failure at a finite slope may occur due to ___________

View solution

Q. If the failure occurs along a surface of sliding that intersect the slope at its toe, the slide is known as ___________

View solution

Q. The types of slip surface or failure surfaces are ____________

View solution

Q. The ratio of total depth to depth H is called _________

View solution

Q. The depth factor Df for toe failure is ___________

View solution

Q. Planar surface commonly occur in __________

View solution

Q. The stability of a finite slope can be investigated by which of the following method?

View solution

Q. According to Bennet, non-circular slip surface may arise in ___________

View solution

Q. The rupture mass sliding down a surface in a definite pattern resembles __________

View solution

Q. In stability computation, the curve representing the real surface of sliding is usually replaced by ___________

View solution

Q. Rectangular plot method has been suggested by _________

View solution

Q. The slip circle having the minimum factor of safety is called ___________

View solution

Q. In Swedish circle method ___________ analysis cases are considered.

View solution

Q. When does the critical condition of d/s slope, occur in reservoir?

View solution

Q. In the rectangular plot method if there are n-slices, the total number of ordinates will be ____________

View solution

Q. Stability of slopes of an earth dam is tested under, which of the following condition?

View solution

Q. When a dam is built of impervious compressible soil, water is entrapped in the pore space due to ___________

View solution

Q. The area of U-diagram in finding stability of D/S slope during steady seepage, can be measured by ___________

View solution