Q. Hansen considered the bearing capacity as a ____________

View solution

Q. Bowel suggested that the increase in φ in plane-strain case can be computed only for φ greater than ____________

View solution

Q. Skempton observed that the factor Nc increases with the ratio ___________

View solution

Q. When D=0, the value of Nc for strip footing will be ____________

View solution

Q. Which of the following value can be taken [Nc] surface for surface footing?

View solution

Q. The term ‘i’ in Hansen equation represents ___________

View solution

Q. When the water table is above the base of the footing, the submerged weight ‘γ’ can be used to compute __________

View solution

Q. Which of the following is an essential difference between Vesic’s and Hansen’s procedure?

View solution

Q. The equation Nc = (Nq – 1) cot φ, have been adopted by ___________

View solution

Q. Which of the following N factors has the widest range of values?

View solution

Q. Which of the following term does not contribute to qf?

View solution

Q. Meyerhof’s extended the analysis of plastic equilibrium of a surface footing to __________

View solution

Q. In the Bowl’s method for finding the effect of water table, which of the following factor is used for soil in the wedge zone?

View solution

Q. Which of the following equation has been recommended by Indian standard for finding reduction factor in water table?

View solution

Q. The value of Nc and Nq are same for, which of the following methods?

View solution

Q. The factor N γ(M) identifies which of the following author?

View solution

Q. IS code recommends a bearing capacity equation, which is similar to __________

View solution

Q. According to IS code, there are __________ types of failures of soil support beneath the foundation.

View solution

Q. The bearing capacity equation for strip footing as given IS standard, can be modified on the basis of ___________

View solution

Q. The value of shape factor S c, S q and S γ for circular base is _________

View solution