Q. The method that can be used for designing raft, based on elastic method?

View solution

Q. The actual reinforcement provided should be ___________ of that worked out theoretically by conventional method.

View solution

Q. The conventional method for designing raft foundation is based on which of the following assumptions?

View solution

Q. The possible method adopted for designing of raft foundation is ___________

View solution

Q. According to IS codes, the maximum differential settlements should not exceed ___________ in the foundation on clayey soil.

View solution

Q. The net pressure can be calculated for raft having width greater than ___________

View solution

Q. If the penetration resistance N is less than 5, which of the following measures can be adopted?

View solution

Q. The penetration resistance N for designing of raft should be taken at ___________ intervals.

View solution

Q. Raft is subdivided in to series of beams to establish __________

View solution

Q. In raft footing, if the C.G of the load coincide with the centroid of the raft, the upward load is considered as ___________

View solution

Q. The net ultimate bearing capacity for raft may be determined by __________

View solution

Q. If a maximum settlement of 50 mm is permitted for a raft, the differential settlement must not exceed ___________

View solution

Q. The weight of the raft is not considered in the structural design, because ___________

View solution

Q. Usually, rafts are designed as _________

View solution

Q. The foundation that is used when the soil mass is sufficiently erratic?

View solution

Q. What will be the shape of footing if a=0, is substituted in the pressure intensity equation “q2 = a. qs”?

View solution

Q. The design procedure of strap footing is essentially that of _____________

View solution

Q. Generally combined footing is assumed to rest on ___________

View solution

Q. For a rectangular combined footing, x̅ is given as ___________

View solution

Q. In designing rectangular combined footing _________ should be adopted as the design value.

View solution