Question
a.
10 Nm
b.
30 Nm
c.
40 Nm
d.
60 Nm
Posted under Textile Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Drawframes equipped with Herrison's cylinder, barrel cylinder and elastic nip are suitable for fourth spinning step, where yarns produced are finer than
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Mechanical feed rate of Herrison-small barrel cylinders is
View solution
Q. Feeler data of mechanical autoleveller is sent to
View solution
Q. When drawing is done with action of needles on short fibers near draft rollers then system in use is called as
View solution
Q. One of vertical axes pulley of feeler features fixed groove while other features
View solution
Q. Deformation of rubber cot exerts a reaction pressure that
View solution
Q. Fibre control is enhanced by number of spikes due to the
View solution
Q. Apron on bottom of guide rollers of draw frame with draft control by means of elastic nip roller, provides
View solution
Q. When spikes row is staggered, it makes fibers
View solution
Q. Feeler of mechanical autoleveller is connected to a lever system that
View solution
Q. Adjustment range of mechanical draft autoleveller varies with respect to weight of
View solution
Q. Elastic nip during action of Herrison cylinders helps In
View solution
Q. Speed of teeth tips of controllers in disk type drawing head is
View solution
Q. Rollers in intersecting rotating disks drawing head are coated with
View solution
Q. Adjustment of fibre compression is allowed with use of rubber cots of varying
View solution
Q. Drawframes equipped with intersecting rotating disks used in pre spinning stages are
View solution
Q. In case of short fibers, control must be adjusted in a way to get
View solution
Q. In order to check fibers without causing any eventual problems, different points of teeth of controller must operate at speed
View solution
Q. When memory speed increases, feeler accuracy
View solution
Q. Diameter of Herrison's cylinder reduces the
View solution
Q. Width of intersecting rotating disks coated with teeth having one head per machine is calculated to be
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Textile Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!