Q. Mass of traveler establishes the

View solution

Q. Travel of rail on which rings are attached is always

View solution

Q. In order to achieve highest speed, traveler's shape must correspond to shape of

View solution

Q. Spinning machines using greater number of spindles must incorporate

View solution

Q. Dividers in ring spinning frame follow travel of

View solution

Q. Difference between peripheral speed of bobbin and traveler is equal to peripheral speed of

View solution

Q. Due to few fibers in fibre mass entering draft range, friction is

View solution

Q. Too much variation of yarn tension leads to

View solution

Q. Distribution of yarn on tube takes place by means of

View solution

Q. Small belt driving spindle ensures

View solution

Q. Control system of ring rail can be

View solution

Q. In case of single control spinning machine in tangential belt system, one shaft drives

View solution

Q. Heavier traveler mass results in

View solution

Q. When bobbin is wounded with yarn, anti-balloon ring carries out

View solution

Q. Upper delivery cylinder as compared to lower one is some degrees

View solution

Q. In case of larger traveler mass, take up tension of yarn will be

View solution

Q. Friction between yarn and ring may result in

View solution

Q. Mass of traveler and balloon size are

View solution

Q. Friction of yarn produced on ring surface may cause

View solution

Q. Maximum speed for steel traveler is calculated to be

View solution