Q. When magnetic meridian is right side to true meridian, then Magnetic Declination is said to be _________

View solution

Q. When magnetic meridian is left side to true meridian, then Magnetic Declination is said to be ________

View solution

Q. The length of a line measured with a 20 m chain was found to be 250 m. Calculate the true length of the line if the chain was 10 cm too long.

View solution

Q. The length of a survey line was measured with a 20 m chain and was found to be equal to 1200 m. If the length again measured with 25 m chain it is 1212 m. On comparing the 20 m chain with the test gauge, it was found to be 1 decimeter too long. Find the actual length of 25 m chain used.

View solution

Q. A surveyor measured the distance between two points on the plan drawn to a scale of 1 cm is equal 40 m and the result was 468 m. But, actual scale is 1 cm = 20 m. Find the true distance between the two points.

View solution

Q. If L is true length of chain and L’ is incorrect length of the chain the correction to area A is _________

(Where ∆L/L = e, e is small and A’ is measured area)

View solution

Q. If L is true length of chain and L’ is incorrect length of the chain the correction to Volume V is _______

(Where ∆L/L = e, e is small and V’ is measured area)

View solution

Q. The difference between a measurement and the true value of the quantity measured is _____

View solution

Q. The difference between the two measured values of the same quantity is ______

View solution

Q. Which of the following are not sources of errors?

View solution

Q. A tape may be too long or an angle measuring instrument may be out of adjustment. Then such type of error comes under which source of error?

View solution

Q. Investigation of observations of various types shows that accidental errors follow a definite law. This law is called ______

View solution

Q. A line which joins subsidiary stations on the main line is called _____

View solution

Q. In which type of surveying only linear measurements are made?

View solution

Q. A survey station is prominent on the chain line and can be either at the beginning of the chain or at the end. Such stations are known as ______

View solution

Q. What is laid by joining the apex of the triangle to any point on the opposite side or by joining two points on any two sides of a triangle?

View solution

Q. The accuracy in the location of the objects depends upon the accuracy in laying the ________

View solution

Q. Survey stations must be mutually visible to obtain a good system of line.

View solution

Q. In case, to get a well-proportioned or well-shaped triangle, no angle should be less than _________

View solution

Q. Each triangle or portion of a skeleton must be provided with sufficient tie lines to obtain good system of lines.

View solution