Q. Fluorescent X-ray spectrometers would require only moderate-intensity X-ray tubes.

View solution

Q. Which of the following components of the X-ray fluorescent spectrometer induces fluorescent radiation?

View solution

Q. Why is a mono-energetic radiation source required in X-ray fluorescent spectrometer?

View solution

Q. Which of the following does not make the X-ray tube nearly monochromatic?

View solution

Q. Which of the following components make use of a thin metal foil to isolate a nearly mono-energetic excitation beam?

View solution

Q. Energy dispersive system uses which of the following detectors?

View solution

Q. In Energy dispersive system, the energy level and the number of pulses is related to which of the following?

View solution

Q. The analysis of X-ray beam by diffraction is similar to spectrum analysis carried out with a diffraction grating.

View solution

Q. The crystal used as X-ray grating has _______ dimensional lattice arrays.

View solution

Q. Which of the following can be done to avoid loss of intensities of X-rays due to the absorption of long wavelength X-rays?

View solution

Q. In curved crystal arrangement, angular velocity of the crystal is twice that of the detector.

View solution

Q. Which of the following is the disadvantage of silicon semiconductor detector?

View solution

Q. In total reflection X-ray fluorescence spectrometer, the specimen is excited by the primary X-ray beam at a grazing angle _______ the critical angle.

View solution

Q. The x-ray beam produced by the primary x-ray tube passes through which of the following components to produce the incident radiation?

View solution

Q. Which of the following crystals are polished to act as the cut-off reflector?

View solution

Q. The suppression of high energy bremsstrahlung radiation improves which of the following?

View solution

Q. Which of the following components are used as the sample carrier?

View solution

Q. Which of the following devices are used as a detector?

View solution

Q. Which of the following happens when a large solid angle is intercepted as the detector is placed close to the sample?

View solution

Q. To monitor the primary beam, which of the following is used?

View solution