Q. What is the purpose of Owens Bridge?

View solution

Q. What is the advantage of Owens Bridge over other AC bridges?

View solution

Q. Which of the following range represents the quality factor of Owens Bridge?

View solution

Q. What is the Common Mode Rejection Ratio?

View solution

Q. Which of the following is not a characteristic of an ideal op-amp?

View solution

Q. For an inverting amplifier positive terminal of input is connected to ____________ of 741 IC.

View solution

Q. In 741 IC, pin number 4 is represented by __________

View solution

Q. Which of the following cannot be treated as a requirement of the instrumentation amplifier?

View solution

Q. Amplifier with power supply and output circuits galvanically isolated are called ______________

View solution

Q. Voltage follower is also known as ___________

View solution

Q. Which configuration of op-amp is used for filter circuit?

View solution

Q. Amplification of low level signal can be done using___________

View solution

Q. For an ideal op-amp, zero input results in zero output.

View solution

Q. Phase difference between two voltages at frequencies above 10Hz can be measured using _________

View solution

Q. What is the operating range of X-Y plotter?

View solution

Q. What is the expression for phase angle using X-Y plotter? (Assume t₀ be time interval between zero crossing of signals and T be time period of signals).

View solution

Q. What is the use of flip-flop in electronic phase meters?

View solution

Q. Phase-Sensitive detectors are used for measuring phase of ______________

View solution

Q. Rejection capability of Phase sensitive detector is depended on the averaging time of smoothing filter.

View solution

Q. For what purpose, FET’s are included in phase sensitive detectors?

View solution