Q. Emf and torque produced in a DC machine are proportional to ________ and _________ respectively.

View solution

Q. What is the value of Np in an average coil emf equation, for 10 armature conductors with 2 parallel paths?

View solution

Q. What is the torque equation in terms of B, Ic, l, Zr (r= mean air gap radius)?

View solution

Q. What is the value of pole pitch (in SI unit) for mean air gap radius= 0.5 mm and P=4?

View solution

Q. A 4-pole Dc wound machine is lap wound with 400 conductors. The pole shore is 20 cm long and average flux density over one-pole pitch is 0.4 T, the armature diameter being 30 cm. What is the value of flux/pole?

View solution

Q. A 4-pole Dc wound machine is lap wound with 400 conductors. The pole shore is 20 cm long and average flux density over one-pole pitch is 0.4 T, the armature diameter being 30 cm. What is the value of induced emf?

View solution

Q. Coil torque for 20 kA armature current (T1) and 40 mA armature current (T2), will have ratio T1/T2=____ (assuming all other parameters same for both machines).

View solution

Q. If the no load speed of DC motor is 1300 rpm and full load speed is 1100 rpm, then its voltage regulation is ____________

View solution

Q. If the average coil emf of a DC motor is doubled and flux is halved (keeping other parameters constant) then its shaft speed will become ___________

View solution

Q. A 4-pole wave wound DC motor drawing an armature current of 20 A has provided with 360 armature conductors. If the flux per pole is 0.015 Wb then the torque developed by the armature of motor is _______

View solution

Q. In a DC machine, what is the torque induced beyond the pole shoes?

View solution

Q. For a constant emf, if field current is reduced then the speed of the DC motor will_____

View solution

Q. For an ideal DC machine, which phenomenon will reduce the terminal voltage?

View solution

Q. Product of torque and mechanical angular velocity ω is_____

View solution

Q. Condition for linear magnetization is______

View solution

Q. A 4-pole Dc wound machine is lap wound with 400 conductors. The pole shore is 20 cm long and average flux density over one-pole pitch is 0.4 T, the armature diameter being 30 cm. Here, motor is drawing 25 A current at 1500 rpm.

What is the available torque (N-m) at shaft?

View solution

Q. When Ea>Vt machine is said to be operating in which of the following mode?

View solution

Q. When Ea<Vt machine is said to be operating in which of the following mode?

View solution

Q. Simple equation of DC machine operating in generating mode, with non-zero Ra value is________

View solution

Q. Simple equation of DC machine operating in motoring mode, with non-zero Ra value is________

View solution