Q. Which of the following is not possible when the signal is analog?

View solution

Q. The transmission of data by dots and dashes is an example of ___________

View solution

Q. What device is used to prevent power from the transmitter from going to the receiver side?

View solution

Q. What generates the final carrier frequency?

View solution

Q. Frequency multiplier multiplies the frequency deviation produced by the modulator.

View solution

Q. ______ is used to provide continuous tuning over the desired range?

View solution

Q. What is the only oscillator capable of meeting the precision and stability demanded by the FCC?

View solution

Q. The device that maintains controlled temperature for crystal oscillators are called __________

View solution

Q. What is the maximum frequency of a 16-MHz crystal with a stability of 200 ppm?

View solution

Q. Calculate the transmitter output frequency if the transmitter uses a crystal oscillator with a frequency of 14.9 MHz and a frequency multiplier chain with factors of 2, 3, and 3.

View solution

Q. Calculate the frequency for maximum drift of crystal if The crystal has a stability of 6300 ppm and an output frequency of 268.2 MHz and frequency multiplier chain with factors of 2, 3, and 3.

View solution

Q. What is the minimum frequency of a 16-MHz crystal with a stability of 200 ppm?

View solution

Q. Which of the following are the two main characteristics of receivers?

View solution

Q. What circuit provides the initial selectivity in a receiver?

View solution

Q. The ability to pick up week signals by a receiver is called _________

View solution

Q. What is the input signal level that is approximately equal to the average internally generated noise value called?

View solution

Q. Analog signals : Signal to noise ratio:: Digital signals _________

View solution

Q. A sensitive and selective receiver can be made using only amplifiers, selective filters, and a demodulator.

View solution

Q. What type of receivers converts all incoming frequency into a lower frequency for better selectivity and sensitivity?

View solution

Q. What is the output of a mixer circuit?

View solution