Q. What is the reason for carrying multiple transponders in a satellite?

View solution

Q. Why are VHF, UHF, and microwave signals used in satellite communication?

View solution

Q. What is the reason for shifting from c band to ku band in satellite communication?

View solution

Q. Which of the following bands cannot be used for satellite communication?

View solution

Q. What is the maximum theoretical data rate if a transponder is used for binary transmission and has a bandwidth of 36 MHz?

View solution

Q. Why are techniques like frequency reuse and spatial isolation carried out?

View solution

Q. Which technique uses two different antennas to reduce traffic on the same frequency?

View solution

Q. Which technique uses spot beam antennas to divide the area covered by the satellite into smaller segments?

View solution

Q. Spatial-division multiple access (SDMA) depends on satellite location and not frequency.

View solution

Q. Which of the following is not a satellite subsystem?

View solution

Q. Which of the following is not a part of the propulsion subsystem of a satellite?

View solution

Q. Which of the following are common baseband signals transmitted from the earth ground station?

View solution

Q. Which of the following components receives, translates the signal frequency and re-transmits the signal in a satellite?

View solution

Q. Why is there a huge spectrum space between the transmitted and received signal in satellite communication?

View solution

Q. Which of the following transponders convert the uplink signal to downlink signal using two mixers

View solution

Q. In a regenerative transponder, the signal is demodulated and modulated again before transmission.

View solution

Q. What is the number of transponders if the satellite uses 12 channels of frequency and frequency reuse is implemented?

View solution

Q. Why is it not possible to provide transmit function by wideband amplifier and mixer circuits?

View solution

Q. Which of the following is not true?

View solution

Q. Telemetry, command, and control (TC and C) subsystem allow a ground station to monitor and control conditions in the satellite.

View solution