Q. What is the distance between the gauge faces of tongue rail and stock rail called?

View solution

Q. What is the major advantage of straight tongue rails?

View solution

Q. Which of the following is not true about length of tongue rails?

View solution

Q. Curved tongue rails can only be used on specific curvature for which they are designed.

View solution

Q. What is done to ensure that at the wheel negotiates the gap of crossing properly?

View solution

Q. Which two rails are machined to form a nose?

View solution

Q. What is the thickness of fine end of Point rail?

View solution

Q. Which type of crossing is formed when a right or left rail crosses a similar rail?

View solution

Q. Which of the following is not true about Built up crossing?

View solution

Q. There are no bolts in cast steel crossing.

View solution

Q. Which of the following is not an advantage of CMS crossing?

View solution

Q. What type of crossing can be used when there is high speed traffic on main track and low speed on turnout track?

View solution

Q. At a crossing the right hand and left hand wing rail converge to form a throat and then merge into a single rail.

View solution

Q. Which formula is used for the calculation of number of crossing based on Centre line method?

View solution

Q. What is another name of Coles method?

View solution

Q. All the methods used for determining the number of crossing give the same value.

View solution

Q. What is the limiting wear for a crossing?

View solution

Q. What is done for reconditioning of crossings at site?

View solution

Q. Which of the following is used for gas welding of crossings?

View solution

Q. What is the distance from the tangent point to the heel of switch is called?

View solution