Q. Which of these factors don’t cause Internal Irreversibility of a Rankine cycle?

View solution

Q. What is the unit of Heat rate?

View solution

Q. Rankine cycle operating on low pressure limit of p1 and high pressure limit of p2 ___________

View solution

Q. Rankine efficiency of a Steam Power Plant ___________

View solution

Q. Rankine cycle comprises of ___________

View solution

Q. In Rankine cycle, the work output from the turbine is given by ___________

View solution

Q. Which of the following contributes to the improvement of efficiency of Rankine cycle in a Thermal Power Plant?

View solution

Q. Match the following:

i) Boiler A. reversible adiabatic expansion of steam

ii) turbine B. constant pressure heat heat addition

iii) Condenser C. reversible adiabatic compression

iv) pump D. constant pressure heat rejection

View solution

Q. What is the actual turbine inlet temperature in Rankine cycle?

View solution

Q. Rankine cycle efficiency of a good Steam Power Plant may be in the range of?

View solution

Q. A simple Rankine cycle operates the Boiler at 3 MPa with an outlet temperature of 350°C and the Condenser at 50 kPa. Assuming ideal operation and processes, what is the thermal efficiency of this cycle?

View solution

Q. A simple Rankine cycle produces 40 MW of power, 50 MW of process heat and rejects 60 MW of heat to the surroundings. What is the utilization factor of this co generation cycle neglecting the pump work?

View solution

Q. A gas turbine works on __________

View solution

Q. What is the range of Thermal efficiency in the Brayton cycle?

View solution

Q. What is the maximum possible TIT(Turbine Inlet Temperature)?

View solution

Q. A simple Brayton cycle uses Helium as the working fluid, has a maximum temperature of 1000 K, and a pressure ratio of 4. At the start of the compression, the Helium pressure and temperature are 50 kPa and 250 K. Based upon cold-air standard analysis assumptions, the thermal efficiency of the cycle is?

View solution

Q. A simple Brayton cycle has a pressure ratio of 5 and a maximum temperature of 900 K. Air enters the compressor at 100 kPa, 300 K. Based upon cold-air standard analysis assumptions, the back-work ratio of this cycle is?

View solution

Q. Which of the following methods can be used to increase efficiency of a Brayton cycle?

View solution

Q. For the same maximum pressure and heat input, the most efficient cycle is?

View solution

Q. The compression ratio is the ratio of ____________

View solution