Q. A simple Rankine cycle operates the Boiler at 3 MPa with an outlet temperature of 350°C and the Condenser at 50 kPa. Assuming ideal operation and processes, what is the thermal efficiency of this cycle?

View solution

Q. A simple Rankine cycle produces 40 MW of power, 50 MW of process heat and rejects 60 MW of heat to the surroundings. What is the utilization factor of this co generation cycle neglecting the pump work?

View solution

Q. A gas turbine works on __________

View solution

Q. What is the range of Thermal efficiency in the Brayton cycle?

View solution

Q. What is the maximum possible TIT(Turbine Inlet Temperature)?

View solution

Q. A simple Brayton cycle uses Helium as the working fluid, has a maximum temperature of 1000 K, and a pressure ratio of 4. At the start of the compression, the Helium pressure and temperature are 50 kPa and 250 K. Based upon cold-air standard analysis assumptions, the thermal efficiency of the cycle is?

View solution

Q. A simple Brayton cycle has a pressure ratio of 5 and a maximum temperature of 900 K. Air enters the compressor at 100 kPa, 300 K. Based upon cold-air standard analysis assumptions, the back-work ratio of this cycle is?

View solution

Q. Which of the following methods can be used to increase efficiency of a Brayton cycle?

View solution

Q. For the same maximum pressure and heat input, the most efficient cycle is?

View solution

Q. The compression ratio is the ratio of ____________

View solution

Q. A Sterling engine uses an energy source whose temperature is 727°C and an energy sink whose temperature is 27°C. How much heat must be added to the engine to produce 1 unit of work?

View solution

Q. Which of the following is not a component of Brayton cycle?

View solution

Q. For a given value of mean temperature of heat addition(Tm) is?

View solution

Q. Mean temperature of heat addition can be increased by?

View solution

Q. Internal irreversibility of Rankine cycle is caused by?

View solution

Q. Which of the following statement is true?

View solution

Q. Pulverized coal is ____________

View solution

Q. What is caking in Power Plants?

View solution

Q. Water gas is a mixture of ___________

View solution

Q. Critical pressure of water is ___________

View solution