Q. What is the function of the trap applied to the condensate?

View solution

Q. Which of these is the correct expression for terminal temperature difference(TTD)?

View solution

Q. If terminal temperature difference (TTD) is too small, what will be its impact on plant efficiency?

View solution

Q. If plant efficiency is high, what will be its effect on heater size?

View solution

Q. When is a drain-cooler used?

View solution

Q. Which of these is a disadvantage of open heater?

View solution

Q. Which of the following is not an advantage of an open heater?

View solution

Q. The number of pumps required by a closed heater for pumping the main feedwater stream is?

View solution

Q. What is the purpose of using open heaters in steam power plants?

View solution

Q. Why are closed heaters sometimes made vertical?

View solution

Q. In the T-S diagram of a Rankine cycle, the abscissa represents?

View solution

Q. After the expansion of throttle steam, why is some steam extracted?

View solution

Q. The heat given up by the expansion of throttle steam is utilised in?

View solution

Q. “Regenerative feedwater heating by turbine extraction” is often termed as?

View solution

Q. A regenerative feedwater heating cycle with an infinite number of feedwater heaters has efficiency equal to?

View solution

Q. In the T-S diagram, the process of heating from condenser to boiler saturation temperature when the number of turbine extraction stages are finite is?

View solution

Q. For the process of heating from condenser to boiler saturation temperature to be reversible, the number of extraction stages involved in the entire cycle should be?

View solution

Q. Which of the processes immediately follows the expansion of throttle steam?

View solution

Q. The output from boiler goes to?

View solution

Q. The area of parallelogram in the T-S diagram representing the cycle output is equal to?

View solution