Q. In the cross-section of the rocker arm, the bending moment is maximum at what point?

View solution

Q. Which of the mentioned below is the formula to calculate the thickness of each eye?

View solution

Q. Which of the mentioned below is the formula to calculate the outer diameter of the eye?

View solution

Q. Which of the mentioned below is the formula to calculate the triangular distribution of the load between the pin and the eye?

View solution

Q. Which of the mentioned below is the formula to calculate uniformly distributed load between the pin and the roller?

View solution

Q. Calculate the diameter of the circular end of the rocker, when d=15 mm?

View solution

Q. The purpose of the valve spring is to exert force on which part?

View solution

Q. When valves are closed which pressure is built inside the cylinder?

View solution

Q. Calculate the mean coil diameter when C=8 and d=6?

View solution

Q. Calculate the total number of turns for a square and ground end when N=13?

View solution

Q. Calculate the free length of the spring when the solid length is 90 mm and δmax=35.75 mm?

View solution

Q. Calculate the solid length of the spring, when Nₜ =15 mm and d= 6 mm.

View solution

Q. Calculate the pitch of the coil when the free length is 131.11 mm and N1 is 15 mm?

View solution

Q. Calculate the maximum force on the spring Pmax when Pᵢ =88.36 N, K=10 and d=25 mm.

View solution

Q. Calculate the width of the flange, when thickness=8.

View solution

Q. Calculate the depth of the section when t=8 mm.

View solution

Q. Pushrods are used in which type of valve mechanized engine?

View solution

Q. Pushrods are connected between which two parts of the valve gear mechanism?

View solution

Q. Which of the mentioned below material is used in pushrod?

View solution

Q. Which type of joint is used at the end of pushrod?

View solution