Q. In which type of combustion chamber hole-type nozzle are preferred?

View solution

Q. What is the opening pressure range in MPa of a hole-type nozzle?

View solution

Q. Which of the following is not a property of a good fuel injector?

View solution

Q. What is the shape of the lower pintle end in a throttling pintle type?

View solution

Q. What is the operating pressure in MPa of a pintle type nozzle?

View solution

Q. In which type of combustion chamber pintle type nozzle injectors are preferred?

View solution

Q. What is the hole angle degree in an upward direction in a multi-hole nozzle?

View solution

Q. Which among the following is not a part of the injector?

View solution

Q. Which among the following is an advantage of the pintle type nozzle?

View solution

Q. How much is the angle of spray cone in a single hole nozzle?

View solution

Q. What is the use of the additional hole present in a pintaux nozzle?

View solution

Q. Based on which principle does the hydraulic governor works?

View solution

Q. Which of the following is an example of a maximum speed governor?

View solution

Q. Which of the following is not a part of a pneumatic governor?

View solution

Q. The difference between which of the following is termed as governor overrun?

View solution

Q. Which of the following links the accelerator pedal and pump control rack in a speed governor?

View solution

Q. What of the following gets actuated when the spring tension is adjusted and the fuel delivery decreases?

View solution

Q. Which of the following is defined as the speed of the fuel injection pump at which the control rod moves away from the maximum fuel to stop with the accelerator lever set for maximum speed?

View solution

Q. Which of the following gives the drive to the governor shaft?

View solution

Q. Which of the following is defined as the percentage speed change when the control rod is moved by the governor from the maximum fuel delivery position to the no-fuel delivery position?

View solution