Question

Which of the following is defined as the speed of the fuel injection pump at which the control rod moves away from the maximum fuel to stop with the accelerator lever set for maximum speed?

a.

Governor cut-off speed

b.

Governor hysteresis

c.

Governor run-off

d.

Governor cut-in speed

Answer: (d).Governor cut-in speed

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Which of the following is defined as the speed of the fuel injection pump at which the control rod moves away from the maximum fuel to stop with the accelerator lever set for...

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Which of the following gives the drive to the governor shaft?

Q. Which of the following is defined as the percentage speed change when the control rod is moved by the governor from the maximum fuel delivery position to the no-fuel delivery position?

Q. Which of the following controls the position of the butterfly valve in the venturi unit?

Q. Which of the following is defined as the difference between the governor cutoff speed at which the fuel delivery stops with the increasing injection pump speed and the cut-off speed at which point fuel delivery just restarts with the decreasing injection pump speed?

Q. Which of the following helps in the idling spring adjustment?

Q. As the engine speed increases, which force acts against the spring tension?

Q. How are the injectors activated in a modern common rail fuel injection system?

Q. Which of the following helps in the increase of the engine torque at lower engine speeds?

Q. In which type of injection mode the exhaust gas temperature for the regeneration of the particulate filter is increased?

Q. How many times is the fuel being injected in one cycle of a modern automotive diesel engine?

Q. Which of the following is not a property for injector open time duration?

Q. Which of the following is an example of a radial piston pump?

Q. Which of the following does not depend on the fuel quantity injected?

Q. Which of the following valve guards the system against excess pressure?

Q. How many numbers of engine variables are individually controlled in a common rail fuel injection system?

Q. Which among the following is not a component of the common rail fuel injection system?

Q. Which among the following is the correct full form of ECU?

Q. How much amount in millimeter cube of fuel is injected in a pilot injection phase?

Q. Which is the sensor used to sense the pressure of the common rail?

Recommended Subjects

Are you eager to expand your knowledge beyond Automotive Engine Design? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!