Q. How much amount in millimeter cube of fuel is injected in a pilot injection phase?

View solution

Q. Which among the following is the correct full form of ECU?

View solution

Q. Which among the following is not a component of the common rail fuel injection system?

View solution

Q. How many numbers of engine variables are individually controlled in a common rail fuel injection system?

View solution

Q. Which of the following valve guards the system against excess pressure?

View solution

Q. Which of the following does not depend on the fuel quantity injected?

View solution

Q. Which of the following is an example of a radial piston pump?

View solution

Q. Which of the following is not a property for injector open time duration?

View solution

Q. How many times is the fuel being injected in one cycle of a modern automotive diesel engine?

View solution

Q. In which type of injection mode the exhaust gas temperature for the regeneration of the particulate filter is increased?

View solution

Q. Which of the following helps in the increase of the engine torque at lower engine speeds?

View solution

Q. How are the injectors activated in a modern common rail fuel injection system?

View solution

Q. As the engine speed increases, which force acts against the spring tension?

View solution

Q. Which of the following helps in the idling spring adjustment?

View solution

Q. Which of the following is defined as the difference between the governor cutoff speed at which the fuel delivery stops with the increasing injection pump speed and the cut-off speed at which point fuel delivery just restarts with the decreasing injection pump speed?

View solution

Q. Which of the following controls the position of the butterfly valve in the venturi unit?

View solution

Q. Which of the following is defined as the percentage speed change when the control rod is moved by the governor from the maximum fuel delivery position to the no-fuel delivery position?

View solution

Q. Which of the following gives the drive to the governor shaft?

View solution

Q. Which of the following is defined as the speed of the fuel injection pump at which the control rod moves away from the maximum fuel to stop with the accelerator lever set for maximum speed?

View solution

Q. What of the following gets actuated when the spring tension is adjusted and the fuel delivery decreases?

View solution