Question
a.
Slip fit
b.
Press-fit
c.
Friction fit
d.
Hydraulic dilation
Posted under Automotive Engine Design
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Which type of fit is used with the block in a wet liner?
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Which among the following material is most commonly used in the manufacturing of cylinder liner?
View solution
Q. Which of the following is not the reason for the breaking of the flange in a wet liner?
View solution
Q. Which of the following is coated outside along with a conventional cast-iron sleeve in a hybrid liner?
View solution
Q. What is the maximum pressure value in the bar of a hybrid liner?
View solution
Q. What is the percentage of heat transfer rate in a hybrid liner?
View solution
Q. What is the percentage of maximum second-order bore distortion in a conventional cast-in liners?
View solution
Q. Which of the following technique is used to limit the crank formation in a hybrid liner?
View solution
Q. Which of the following results in a decrease in the scuffing near the sealing ring area?
View solution
Q. What is the wall thickness in millimeter preferred between cylinder bores in a hybrid liner?
View solution
Q. Which are the two materials used in a bimetallic piston?
View solution
Q. Which among the following is provided on the pistol in a two-stroke engine to increase the compression ratio?
View solution
Q. Which among the following is the correct formula of the compression ratio in terms of clearance volume and swept volume?
View solution
Q. By adding which of the following material to aluminum alloy piston slap can be avoided?
View solution
Q. Which among the following casting process is used in the casting of the piston?
View solution
Q. Which of the following is not a method to avoid piston slap?
View solution
Q. Which is the material used to wound on a wire wound piston?
View solution
Q. Which among the following type is named when the silicon content is 12% in an aluminum alloy?
View solution
Q. Which of the following is the main reason for a burnt piston?
View solution
Q. Which of the following is not a reason for piston failure?
View solution
Q. Which if the following is defined as the distance between the axis of the piston pin and top of the piston crown?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Automotive Engine Design? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
