Q. What is the wall thickness in millimeter preferred between cylinder bores in a hybrid liner?

View solution

Q. Which are the two materials used in a bimetallic piston?

View solution

Q. Which among the following is provided on the pistol in a two-stroke engine to increase the compression ratio?

View solution

Q. Which among the following is the correct formula of the compression ratio in terms of clearance volume and swept volume?

View solution

Q. By adding which of the following material to aluminum alloy piston slap can be avoided?

View solution

Q. Which among the following casting process is used in the casting of the piston?

View solution

Q. Which of the following is not a method to avoid piston slap?

View solution

Q. Which is the material used to wound on a wire wound piston?

View solution

Q. Which among the following type is named when the silicon content is 12% in an aluminum alloy?

View solution

Q. Which of the following is the main reason for a burnt piston?

View solution

Q. Which of the following is not a reason for piston failure?

View solution

Q. Which if the following is defined as the distance between the axis of the piston pin and top of the piston crown?

View solution

Q. Which material is coated on the piston to increase the service life?

View solution

Q. Which among the following is not a function of the piston rings?

View solution

Q. Which of the following is provided to make up for the cylinder wear?

View solution

Q. Which among the following is defined as percentage gap collapse when the ring closed to nominal cylinder diameter for 6 hrs at 350 degrees centigrade?

View solution

Q. Which of the following is not a factor for scuffing?

View solution

Q. Which among the following type of piston ring is used for worn-out cylinders?

View solution

Q. Which of the is caused due to excess of end gap?

View solution

Q. Which of the following is not an advantage of reducing the ring width?

View solution