Q. Large temperature differentials within the concrete member may promote __________

View solution

Q. When the concrete in fresh stage is exposed to freeze before certain pre-hardening period, compressive strength may get __________

View solution

Q. Concrete is not recommended to be placed at a temperature above _________ºC.

View solution

Q. IS: 7861 part-1 deals with ___________

View solution

Q. A higher temperature of fresh concrete results in a __________ hydration of cement.

View solution

Q. Does this reduce handling time?

View solution

Q. Rapid evaporation may cause plastic shrinkage __________

View solution

Q. It is difficult to retain moisture for hydration for rapid evaporation of water during curing period.

View solution

Q. Prepacked concrete _________ water proofing concrete.

View solution

Q. Cement has ________ % volumetric shrinkage after curing.

View solution

Q. After vacuum mixing, the volumetric shrinkage can be raised from 3–5% to __________ % in different cements.

View solution

Q. Vacuum mixing systems reduce the exposure by _________ %.

View solution

Q. The exposure of conventional mixing in open bowl is about ___________ ppm in the breathing zone.

View solution

Q. The __________ compressive strength required from structural consideration.

View solution

Q. The adequate workability necessary for ___________ compaction with the compacting equipment available.

View solution

Q. ___________ water-cement ratio content to give adequate durability for the particular site conditions.

View solution

Q. _______ cement content to avoid shrinkage cracking due to temperature cycle in mass concrete.

View solution

Q. ________ has designated the concrete mixes into a number of grades as M10, M15.

View solution

Q. Maximum nominal size of aggregates to be used in concrete may be as large as possible within the limits prescribed by _______

View solution

Q. Identify the type of destructive testing.

View solution