Question

RF integrated circuits generally comprise of _____

a.

resonators and resistors

b.

resistors

c.

diodes

d.

resonators and capacitors

Posted under Cognitive Radio

Answer: (d).resonators and capacitors Explanation:RF integrated circuits consist of off-chip resonators, inductors, and capacitors. Each device increases the production cost which is linear function of number of components.

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. RF integrated circuits generally comprise of _____

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. RF MEMS gives _______ alternative to electronic switching circuits.

Q. Which of these is not a technique used to induce sharp resonance in resonators?

Q. In resonators with nanoscale I-beams, which factor does not affect the mechanical frequencies of I-beams?

Q. The industry standard figure of merit for an RF switch is ______

Q. RF MEMS allows selection of ____ and ____, increasing the degree of freedom in design process.

Q. Superconducting analog filters can reduce noise and interference introduced by wide bandwidth of SDR architecture.

Q. Superconductors use ____ to maintain working temperature near _____.

Q. F amplifiers tend to be ____ amplifiers.

Q. Which of the following modulation type is incompatible with class C operation?

Q. Electronically Programmable Analog Components are also called as ____

Q. Which of the following is not a challenge to RF/IF conversion stage in military application?

Q. ____ fixes the input power dynamic range such that there are no sinusoidal RF conversion artifacts in the output.

Q. The Nyquist criterion states that the sampling frequency of a band limited analog waveform must be at least ______ component to properly reconstruct the signal.

Q. The useful dynamic range applicable for antenna, RF/IF conversion, and ADC’s is given by the ratio of smallest processable signal to the smallest detectable signal.

Q. Which of the following is the first step in establishing acceptable aliasing power?

Q. Noise must be less than _____ of the ADC.

Q. To avoid aliasing, the wideband ADC is ____ by anti-aliasing filters to suitably alter the _____ waveform.

Q. The shape factor of an anti-aliasing filter is given by the ratio of the frequency at ___ dB attenuation point to the frequency at ___ dB point.

Q. Which among the following filters has the slowest roll-off?

Q. Which of the following expressions give the relation between power and quantization step size (q)?

Recommended Subjects

Are you eager to expand your knowledge beyond Cognitive Radio? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!