Question

How are the bits at the output of INFOSEC (towards source) stage referred?

a.

Black bits

b.

Shielded bits

c.

White bits

d.

Clear bits

Posted under Cognitive Radio

Answer: (d).Clear bits Explanation:The bits at the output of INFOSEC are referred to as clear bits. These are then operated on to give network or source bits. Network bits comply with network protocols and the source bits are passed to source decoder.

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. How are the bits at the output of INFOSEC (towards source) stage referred?

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. _____ stream characterizes radio surrounding usage in terms of time, frequency, and space.

Q. Digital-access bandwidth is approximately double of the sampling rate of the ADC in the isochronous subscriber signal-processing path.

Q. The introduction of plug and play modules in software defined radio involves partitioning of functions and components

Q. Which among the following is not a part of RF front-end section in receive mode?

Q. The circuits of transmit mode in RF front end _____ RF signal.

Q. ____ time aligns a signal and fits it into the information bandwidth.

Q. The number of times an electronic signal changes its state is measured by ____

Q. The modem may include ____ to correct channel multipath artifacts.

Q. ____ can be used to correct encoded symbols received in error.

Q. The modem groups the bits to be transmitted into ____

Q. A ____ is used to represent a symbol.

Q. ____ depends on the amount of redundancy in a data stream.

Q. The modem must control ____ to produce the desired carrier frequency.

Q. Speech application typically runs on ____ processor.

Q. Which of the following is not a characteristic of cryptographic security?

Q. ____ is used to identify the creator of information.

Q. Encryption is a generalized process.

Q. The modem controls the antenna matching unit to maximize voltage standing wave ratio.

Q. ____ is used to optimize voltage standing wave ratio.

Q. In ____ antenna, the interface boundary between radio and antenna is blurred.

Recommended Subjects

Are you eager to expand your knowledge beyond Cognitive Radio? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!