Q. If an incompressible liquid is continuously flowing through a pipe, the quantity of liquid passing per second is different at different sections.

View solution

Q. The atmospheric pressure at sea level is

View solution

Q. When the pressure intensity at a point is less than the local atmospheric pressure, then the difference of these two pressures is called vacuum pressure.

View solution

Q. Reynold's number is the ratio of inertia force to

View solution

Q. The unit of dynamic viscosity in S.I. units is

View solution

Q. Bulk modulus of a fluid __________ as the pressure increases.

View solution

Q. The hydraulic gradient line may be above or below the centre line of the pipe.

View solution

Q. A water tank contains 1.3 m deep water. The pressure exerted by the water per metre length of the tank is

View solution

Q. The specific gravity has no units.

View solution

Q. The depth of water in a channel corresponding to the minimum specific energy is known as critical depth.

View solution

Q. The ratio of the inertia force to the gravity force is called Froude number.

View solution

Q. Which of the following statement is wrong?

View solution

Q. A glass tube of smaller diameter is used while performing an experiment for the capillary rise of water because

View solution

Q. The viscosity of a liquid is due to cohesion of its particles.

View solution

Q. A compound pipe is required to be replaced by a new pipe. The two pipes are said to be equivalent, if

View solution

Q. In a footstep bearing, if the speed of the shaft is doubled, then the torque required to overcome the viscous resistance will be

View solution

Q. The viscosity of water is __________ than that of mercury.

View solution

Q. An open tank containing liquid is made to move from rest with a uniform acceleration. The angle 0 which the free surface of liquid makes with the horizontal is such that (where a = Horizontal acceleration of the tank, and g = Acceleration due to gravity)

View solution

Q. The discharge over a triangular notch is

View solution

Q. The discharge through an external mouthpiece is given by (where a = Cross-sectional area of the mouthpiece, and H = Height of liquid above the mouthpiece)

View solution