Q. A fluid which obeys the Newton's law of viscosity is termed as

View solution

Q. A notch is, usually, made of a metallic plate.

View solution

Q. In an internal mouthpiece, if the jet after contraction expands and fills up the whole mouthpiece, then the mouthpiece is said to be running free.

View solution

Q. A channel is said to be of most economical cross-section, if

View solution

Q. The top of the weir over which the water flows is known as

View solution

Q. A moving fluid mass may be brought to a static equilibrium position, by aplying an imaginary inertia force of the same magnitude as that of the accelerating force but in the opposite direction. This statement is called

View solution

Q. The pressure at a stagnation point is always low.

View solution

Q. When an internal mouthpiece is running full, the discharge through the mouthpiece is twice the discharge when it is running free.

View solution

Q. In two dimensional flow, the flow does not take place in a curve.

View solution

Q. In order to avoid tendency of separation at throat in a venturimeter, the ratio of the diameter at throat to the diameter of pipe should be

View solution

Q. The ratio of the inertia force to the __________ is called Euler's number.

View solution

Q. When the flow in an open channel is gradually varied, the flow is said to be

View solution

Q. When the Mach number is equal to unity, the flow is called sonic flow.

View solution

Q. The total pressure on the bottom of a closed cylindrical vessel completely filled up with a liquid is the sum of the total centrifugal pressure and the weight of the liquid in the vessel.

View solution

Q. A weir, generally, used as a spillway of a dam is

View solution

Q. A thick liquid like a syrup has a __________ viscosity than a light liquid like water.

View solution

Q. The highest efficiency is obtained with a channel of __________ section.

View solution

Q. A vessel of 4 m³ contains an oil which weighs 30 kN. The specific weight of the oil is

View solution

Q. Coefficient of discharge Cd is equal to (where Cc = Coefficient of contraction, Cv = Coefficient of velocity, and Cr = Coefficient of resistance)

View solution

Q. In an internal mouthpiece, if the jet after contraction does not touch the sides of the mouthpiece, then the mouthpiece is said to be

View solution