Q. Euler's equation can be used for

View solution

Q. A rocket engine uses __________ for the combustion of its fuel.

View solution

Q. The perfect intercooling, in multistage compression, means that the temperature of air at inlet to subsequent stages is equal to the initial temperature.

View solution

Q. A closed cycle gas turbine consists of a

View solution

Q. For maximum work, the reheating should be done to an intermediate pressure of (where p1 = Maximum pressure, and p2 = Minimum pressure)

View solution

Q. The intercooler pressure, for minimum work required, for a two stage reciprocating air compressor, is given by (where p1 = Intake pressure of air, p2 = Intercooler pressure, and p3 = Delivery pressure of air)

View solution

Q. The pressure of air at the beginning of the compression stroke is __________ the atmospheric pressure.

View solution

Q. The pressure ratio in a centrifugal compressor can be increased by increasing the tip speed and lowering the inlet temperature.

View solution

Q. If p1 is the pressure of air entering the L.P, cylinder and p3 is the pressure of air leaving the H.P. cylinder, then the ratio of cylinder diameters for a single acting, two stage reciprocating compressor with complete intercooling is given by

View solution

Q. Reheating in a gas turbine

View solution

Q. In a single stage, single acting reciprocating air compressor, without clearance, the workdone on the air during isentropic compression is __________ the heat required to raise the temperature of air from T1 to T2 at a constant pressure.

View solution

Q. Workdone by an air compressor __________ upon the way in which the air is compressed.

View solution

Q. In a compressor, work is done on the piston during suction of air and work is done by the piston during compression as well as delivery of air.

View solution

Q. In a compressed air system, the temperature of air discharged from the air motor is __________ than the initial compressor intake temperature.

View solution

Q. The efficiency of roots blower __________ with the increase in pressure ratio.

View solution

Q. The operation of lifts, rams and pumps make use of compressed air.

View solution

Q. A jet engine has

View solution

Q. A receiver in compressor installations is used to damp pressure waves in compressor discharge.

View solution

Q. The axial flow compressor is preferred in air-craft gas turbines because of

View solution

Q. Which of the following statement is correct as regard to centrifugal compressors?

View solution