Q. The amount of heat flow through a body by conduction is

View solution

Q. The emissive power of a body depends upon its

View solution

Q. An electric cable of aluminium conductor (k = 240 W/mK) is to be insulated with rubber (k = 0.15 W/mK). The cable is to be located in air (h = 6 W/m²). The critical thickness of insulation will be

View solution

Q. A cube at high temperature is immersed in a constant temperature bath. It loses heat from its top, bottom and side surfaces with heat transfer coefficients of h1, h2 and h3 respectively. The average heat transfer coefficient for the cube is

View solution

Q. The dehumidification process, on the psychrometric chart, is shown by

View solution

Q. The vertical and uniformly spaced lines on a psychrometric chart indicates

View solution

Q. A furnace is made of a red brick wall of thickness 0.5 m and conductivity 0.7 W/mK. For the same heat loss and temperature drop, this can be replaced by a layer of diatomite earth of conductivity 0.14 W/mK and thickness

View solution

Q. In a refrigeration system, the expansion device is connected between the

View solution

Q. The heat rejection factor (HRF) is given by

View solution

Q. Wein's law states that the wave length corresponding to __________ is proportional to the absolute temperature.

View solution

Q. In a domestic vapour compression refrigerator, the refrigerant commonly used is

View solution

Q. In case of sensible heating of air, the coil efficiency is given by (where B.P.F. = By-pass factor)

View solution

Q. The coefficient of performance (C.O.P.) is the reciprocal of the efficiency of a heat engine.

View solution

Q. The wet bulb temperature at 100% relative humidity is __________ dry bulb temperature.

View solution

Q. The freezing point of sulphur dioxide is

View solution

Q. The ratio of the energy absorbed by the body to the total energy falling on it, is called

View solution

Q. In order to cool and dehumidify a stream of moist air, it must be passed over the coil at a temperature

View solution

Q. The coefficient of performance of vapour compression refrigeration system is quite __________ as compared to air refrigeration system.

View solution

Q. In order to collect liquid refrigerant and to prevent it from going to a __________ , a device known as accumulator is used at the suction of compressor.

View solution

Q. Which of the following refrigerant has the lowest boiling point?

View solution